Make your own CarbonFiber case topic

It is actually a very easy project that came up to my mind when i saw my old transcluent (was in a bad shape, totally covered with deep scratches)
Any hardcase should work

Things you will need:

• A spare case lying around


• Carbon Fiber Vinly/Sticker


• A heat gun (In my case hair dryer)


• Utility Knife/Razor


• A needle


• 10 minutes of your life

• Cut apprx. 25x15 cm of carbon fiber (CF) (depends on your case, use as much as you like)


• Apply it, bend excess CF to inside of your case


• apply heat with hair dryer (DONT USE TOO MUCH HEAT) while applying it to the corners for smooter finish


• cut camera and flash holes from back of your case with a razor


• stick a pencil from front of your case to the mic. hole


• cut excesive CF that you bent over from back of your case if it does not fit.


• stick needle to bubbles at 90 degrees if there are any, be sure to not to go too deep, just a small hole should be enough otherwise you will leave dents

It should look something like this;

Attached Thumbnails