I've been playing around with films lately, most screen protectors are crap these days. I wanted something industrial grade. Long story short, pulled off some extra clear bra from a sheet I did my car with. The results are 10 fold better. I used xpel ultimate self healing film.
https://www.xpel.com/products/xpel_u...ction_film.asp - the film really is self healing :D
Tools
Screen roller
Xpel ultimate film - order a decent size you will need extra.
Exacto knife
Very clean work area
Patience & precision!
Installation
1. Clean surface, no dust!
2. Cut film about 3 inches over the size of the actual template, you will leave fingerprints. You need that slack so you can grip it and then cut off the access where you gripped it.
3. Lay it down from top to bottom, this is the most important step. You cannot stop once you start, if you stop you will leave a crease line. You must take the roller and push the film down slowly, consistent but never stop.
4. Repeat rolling until all air bubbles are gone, there should be almost none the first time around. You do not use water with this application.
5. Trim the slack off with an exacto knife. Make sure not to cut in too hard, you don't want to cut into the phones waterproof seal on the edges.
6. Admire your work and of course do a light water test to make sure your z1 seals are good.
Pros
10 mils thick
Self healing - scratches disappear.
Very glossy
Super smooth
Fills in scratches underneath on the stock protector.
Oem look
The most durable out
Grippy on flat surfaces
Cons
Pricey
You have to be good at installing films - you really need a roller or be very consistent. You only get one shot.
You have to trim everything your self
https://www.xpel.com/products/xpel_u...ction_film.asp - the film really is self healing :D
Tools
Screen roller
Xpel ultimate film - order a decent size you will need extra.
Exacto knife
Very clean work area
Patience & precision!
Installation
1. Clean surface, no dust!
2. Cut film about 3 inches over the size of the actual template, you will leave fingerprints. You need that slack so you can grip it and then cut off the access where you gripped it.
3. Lay it down from top to bottom, this is the most important step. You cannot stop once you start, if you stop you will leave a crease line. You must take the roller and push the film down slowly, consistent but never stop.
4. Repeat rolling until all air bubbles are gone, there should be almost none the first time around. You do not use water with this application.
5. Trim the slack off with an exacto knife. Make sure not to cut in too hard, you don't want to cut into the phones waterproof seal on the edges.
6. Admire your work and of course do a light water test to make sure your z1 seals are good.
Pros
10 mils thick
Self healing - scratches disappear.
Very glossy
Super smooth
Fills in scratches underneath on the stock protector.
Oem look
The most durable out
Grippy on flat surfaces
Cons
Pricey
You have to be good at installing films - you really need a roller or be very consistent. You only get one shot.
You have to trim everything your self
